SH Samoan Grooms Pe'a Panel MESH stencil

The Samoan Grooms Pe'a Mesh stencil was created from this drawing sent by the Client. Twisted Flour and Sugar, based in Christchurch airbrushed this special family tatau design onto the wedding cake.

    

Design Size: To Fit 8" cake - 7" x 10.89" - 177.8mm x 276.5mm - This stencil has a 12mm bottom border so the design sits closer to the cake board. 
Note: It is not intended to be repeatable.

Ideal for airbrushing

The normal ibicci Cake Stencils measure approximately 11.75"x8.25” / 30x21cm and most designs are cut to allow the stencils to be trimmed as required for placement on the sides and/or tops of cakes. Strip style cake Mesh stencils may be smaller in height. These stencils should be trimmed with a metal ruler and cutting blade.

Care: Rinse gently with warm water, Do Not use hot water as this may cause warping. Lay flat to dry either smoothing in a clean tea towel or pat dry with paper towels. Ensure they are fully dry before storing. An iron may be used on a very low setting to flatten mesh stencils but care must be taken.