Steampunk Gears MESH stencil

This 4" Steampunk Gears stencil was created after a custom Steampunk Cake 2 tier design was made for Linda Bunt of Cakes for All Occasions.

If you are interested in the same 2 tier stencils are seen here, please contact us

Design Size: 3.98” x 8.64”: - 101.1mm x 219.4mm

BEST Airbrushed or Petal/Metal Dusts used for this design. Buttercream NOT recommended.

The normal ibicci Cake Stencils measure approximately 11.75"x8.25” / 30x21cm and most designs are cut to allow the stencils to be trimmed as required for placement on the sides and/or tops of cakes. Strip style cake Mesh stencils may be smaller in height. These stencils should be trimmed with a metal ruler and cutting blade.

Care: Rinse gently with warm water, Do Not use hot water as this may cause warping. Lay flat to dry either smoothing in a clean tea towel or pat dry with paper towels. Ensure they are fully dry before storing. An iron may be used on a very low setting to flatten mesh stencils but care must be taken.