DS Māori Strip MESH stencils

These custom strip mesh stencils were created to celebrate Isey Cross's 105th Birthday, the cake was made by Donnelle Stirling of Cake in the Box who has done several of Isey's birthday cakes.

Read about her 105th Celebration by clicking on the photo below.

 

Design Sizes :
Panel stencil   (top)           : 0.98” x 11.41” - 25mm x 289.9m - Repeatable design
Line strip stencil (bottom) : 1.04” x 11.09” - 26.5mm x 279.5m - Repeatable design

Ideal for airbrushing, stencilling with soft royal icing, petal dust or metallic powders, gels or for use in crafts (water based recommended).

Mesh stencils are quick to use and enhance items you are decorating. Common ways of using stencils are with magnetic frames such as the Stencil Genie or Stencil Snap, by using magnets on the corners of the stencils, or simply held by hand, taped or with weights. Cake stencils can be taped or pinned for use.

The normal ibicci Cake Stencils measure approximately 11.75"x8.25” / 30x21cm and most designs are cut to allow the stencils to be trimmed as required for placement on the sides and/or tops of cakes. Strip style cake Mesh stencils may be smaller in height. These stencils should be trimmed with a metal ruler and cutting blade.

Care: Rinse gently with warm water, Do Not use hot water as this may cause warping. Lay flat to dry either smoothing in a clean tea towel or pat dry with paper towels. Ensure they are fully dry before storing. An iron may be used on a very low setting to flatten mesh stencils but care must be taken.