Christmas Swirl Tree/Snowflake Cutter/Stencils
Hand Designed originally by Kat specifically for the large Green Christmas Tree cookie cutter (Cutter no longer available), these stencils may be used on other cookies using a blocker or with careful airbrushing.
Design Size for Large Green Tree Cutter : 115mm x 107.6mm - 4.53" x 4.23" - see photo
Design size for 4" cookie: 97mmx91mm
RED TREE 3D Cutter 5" - 12.5cm H x 12cm W - Stencil will fit with 2-3mm allowance for spread
RED TREE 3D Cutter 4" - 10cm H x 9.5cm W - Stencil will fit with 2-3mm allowance for spread
RED SNOWFLAKE 3D Cutter - Either a 'Sharp' or Soft' stencil will be sent with the cutter, depending on what I have in stock. The Snowflake cutter matches the 5" tree better by the way - see the photo for reference.
Please note: As I have no control over what PLA is available, Red may not be available and will be replaced with another colour PLA
Ideal for airbrushing or stencilling with royal icing.
Stencils are quick to use and enhance the cookies or cakes you are decorating. Common ways of using stencils are with magnetic frames such as the Stencil Genie, by using magnets on the corners of the stencils, or simply held by hand. Cake stencils can be taped, pinned or held in place by the use of net. ibicci stencils are primarily made for decorating cookies and cakes however the stencils can be used to apply designs on a wide variety of surfaces including walls, wood, fabric, glass etc.
The ibicci Square stencils measure approximately 5.5" / 14.2cm square and fits the Stencil Genie as shown. ibicci stencils are made out of reusable, sturdy food safe .007mil plastic.
Care: Rinse gently with warm water, Do Not use hot water as this may cause warping. Lay flat to dry or pat dry with paper towels.